Your healthcare provider wants you to change a dressing or perform other care using sterile glove technique. Sterile means germ-free. Sterile glove technique is a way to protect you from infection. You were shown sterile technique in the hospital. This sheet will help you remember those steps when you are at home.
Wear a mask if you are instructed to use one.
Wash your hands before and after any sterile procedure.
Prepare a clean work area each time you use this technique. Don’t work in the bathroom. It has too many germs.
When you handle supplies, be sure to keep them sterile and dry.
If you are handling a packaged sterile product and not wearing gloves, only touch the outside wrapper. Don’t touch the sterile supplies when not wearing gloves.
Don’t reach over the sterile supplies while you are performing your care.
Take pets and children out of your work area.
Clean washable surfaces with soap and water, and dry with a paper towel.
Wipe surfaces that are not washable (such as fabric or wood) so that they are free of dust. Spread a clean cloth or paper towel over your work surface.
If you need to cough or sneeze, cover your work surface and supplies. Move away from them.
Turn on the water.
Wet your hands and wrists.
Use liquid soap from a pump dispenser. Work up a lather.
Scrub your hands well for about 20 seconds (or the time it takes to sing the Happy Birthday song twice)
Rinse your hands with your fingers pointing down toward the drain.
Dry your hands with a paper towel. Use this towel to turn off the faucet.
Once you have washed your hands, don’t touch anything but your supplies. You must wash your hands again if you touch anything else, such as furniture or your clothes.
Open the outer wrap of the sterile glove pack.
Take out the inner wrap.
Put the wrapped sterile gloves on your clean, dry work surface.
Don’t put the wrapped gloves on the sterile supply wrapper.
Open the inner wrapper so that you can see both gloves.
Take the hand you write with and grasp the glove for your other hand at the folded edge of the cuff.
Pick up the glove by the folded edge.
Put your hand inside the glove. Keep your hand flat and your thumb tucked in.
Pull the glove on.
Be careful not to touch the outside of the glove. Touch only the part of the glove that will be next to your skin.
Leave the cuff on the glove folded.
Now, slip the fingers of your gloved hand into the folded cuff of the other glove.
Lift up the second glove.
Put the glove over your fingers. The hand that you are putting the glove on should stay flat. Keep the gloved thumb up and back to keep from touching your bare palm or wrist.
Pull the glove over your hand.
Adjust each glove to get a snug fit.
Reach under the cuffed part to pull up or adjust.
Keep your hands in front of you and above your waist. Don’t touch anything outside the sterile field.
If you break sterile procedure, remove the gloves, get a new package, and start again.
Follow up with your healthcare provider, or as advised.
© 2000-2017 The StayWell Company, LLC. 780 Township Line Road, Yardley, PA 19067. All rights reserved. This information is not intended as a substitute for professional medical care. Always follow your healthcare professional's instructions.