Thermal Disinfection of Soft Lenses

What is thermal disinfection of soft contact lenses?

During normal wear, dirt, protein particles, and germs can get on soft contacts. Thermal (heat) disinfection is one way to kill the germs that can cause serious eye infections. It also protects your eyes from irritation. The rest of the cleaning process removes substances that may shorten the life of the lens.

Thermal disinfection is one of several ways to disinfect soft contact lenses. (Chemical disinfection is more commonly used than thermal disinfection.) When your doctor recommends thermal disinfection, the basic procedure is cleaning, rinsing, disinfecting with heat, and rinsing again.

When is it done?

Soft contacts must be disinfected every time you remove them. If you have daily-wear soft contacts, you will clean and disinfect them every night. If you have extended-wear soft contacts, you will clean and disinfect them every time you take them out. Most eye doctors recommend that all contacts be taken out before sleeping, even extended-wear contacts.

Throw away disposable contacts. Do not try to clean and reuse them.

How is it done?

You will need an electric thermal disinfecting unit (heating unit), a contact lens case made for use with the heating unit, the recommended daily cleaning solution, and the solution recommended for use with your heating unit.

To clean and disinfect your lenses properly, follow these steps:

1. Wash your hands before you remove your lenses. Always handle them gently (soft contacts can tear). Be sure to keep track of which is the right lens and which is the left. It helps if you always handle the right lens first.
2. Cleaning: Remove the lens and put it in the palm of your hand so that it curves up (like a bowl). Pour a few drops of daily cleaner over the lens. Using one finger, rub the lens back and forth. The daily cleaner helps dissolve dirt and oils.
3. Rinsing: Either cradle the lens in your fingertips or leave it in your palm, and rinse it thoroughly using the sterile saline rinsing solution.
4. Disinfecting: Fill the case with the recommended solution. Put the lens in the correct side of the case. Repeat these steps with the left lens. Screw the caps on and put the case into the heating unit. Be sure the unit is plugged in, then turn it on.

Before you use your heating unit for the first time, read the instructions that come with it. Most heating units take 30 to 45 minutes to disinfect your lenses and then cool down. When the heating process is complete, you can put your lenses in your eyes. You may want to rinse them with saline solution before you put them in your eyes. If you do, be sure to use only the sterile saline rinsing solution that your eye doctor has recommended for your lenses.

Rinse the case thoroughly with tap water, and either dry it or let it air dry.

Are any other cleaning procedures necessary?

To help remove protein deposits, your eye doctor may recommend enzyme cleaning. Enzyme cleaning is usually done once every week or two. Using the enzyme cleaner on the same day each week may help you remember when enzyme cleaning is needed. Only certain enzyme cleaners are designed for use with thermal disinfection systems. Be sure that you read the package information carefully before you buy an enzyme cleaner.

Most enzyme cleaners come in tablet form. Use your enzyme cleaner according to the directions on the package. Then clean, disinfect, and rinse your lenses before putting them in.

What solutions should I use?

There are many contact lens care products on the market. Usually your doctor will recommend certain products based on what is best for your contacts and safest for your eyes. Sometimes other products would work equally well. Other times, using different solutions may irritate your eyes or discolor your lenses. Always check with your doctor before changing contact lens solutions. Always read the instructions that come with your products.

Do not store or clean your lenses using tap water or homemade solutions.